![]() ![]() ![]() Do not remove your USB drive or turn off your vehicle while this update is in progress. SYNC displays “Installing Application” during the process.SYNC automatically detects the files on your USB drive and then displays “Install Application?” Press OK to confirm.Make sure it is completely plugged into the port. Plug the USB drive in to your vehicle’s USB port.Turn off Bluetooth on your phone if it is in the vehicle.Make sure that your vehicle is not in Accessory mode. Your vehicle will need to be turned on, with the engine running between ten and thirty five minutes. Make sure your vehicle is in a well-ventilated area. Turn on your vehicle, and then turn on the radio. Take the USB drive with the software updates to your vehicle.NOTE: For this version of the SYNC system your USB device needs to be formatted to FAT32 not exFAT! (you will get an error asking you to make sure the install file is in the root directory).The instructions you actually need are located here. I have a 2012 XLT with the basic system - apparently this means pre SYNC 2 - which means the directions Ford gives on the VIN look-up page are wildly inaccurate and I'm just surprised they don't have it better spelled out. Navigate to and check your VIN for updates and download them via the instructions - this is where their instructions stop being accurate.Wi-Fi is a registered trademark of the Wi-Fi Alliance.Just did mine and had to do a lot of guessing, sleuth work on the forums, and digging on Ford's page to figure it out. **Requires in-vehicle USB mobile broadband connection, PAN-supported mobile device or proximity to an outside wireless hotspot. Not all features are compatible with all phones. Some features may be locked out while the vehicle is in gear. Use voice-operated systems when possible don’t use handheld devices while driving. Is there a cost to download SYNC updates?Ĭan I upgrade from a previous SYNC system to a newer SYNC system? You cannot connect to the vehicle's Wi-Fi Hotspot (if equipped) to install Wi-Fi updates.For Wi-Fi updates, the download time can vary from a few hours to multiple days depending on internet-related factors (Wi-Fi strength, internet speeds, time connected to Wi-Fi network, etc.).Installing USB updates can take up to 45 minutes.Choose USB Drive or Wi-Fi as your preferred installation method and follow the instructions. ![]() Note: If you have the latest SYNC software version, you will see a green checkmark and a message stating that an update is not available for your vehicle. Select the dropdown under SYNC UPDATES.Enter your Vehicle Identification Number (VIN), or sign in to your Ford account and select a vehicle from your garage.Visit the SYNC and Navigation Updates page.Important: If you have SYNC with MyFord, SYNC Gen 1.1, SYNC with Voice-Activated Navigation, SYNC with "P" Navigation, or SYNC Gen 1, you are unable to update SYNC via Wi-Fi or USB and will have to take your vehicle to a Ford Dealer for updates. MyFord Touch ® can only be updated with a USB drive. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |